If your home was built between the late 1970s and the mid-1990s, it may have polybutylene water pipes. Polybutylene is a gray plastic pipe that was widely used during those years because it was easy to install. It’s no longer used because it tends to fail without warning. If your home still has it, repiping is usually the safer long-term choice.
How to Tell If You Have Polybutylene Pipes
Polybutylene pipe is flexible plastic, usually gray. Some supply lines from that era are blue or black. Look for it in these places:
- Near the water heater
- Under kitchen and bathroom sinks
- Where the water line comes into the house
- Behind toilets
- In the attic or crawl space
Many polybutylene pipes are stamped with the code “PB2110.” Fittings are often plastic or copper crimp rings. If you aren’t sure what you’re looking at, a plumber can tell you quickly during a plumbing inspection.
Don’t rely on the pipe you see at a sink. A plumber may have replaced a short section there while polybutylene still runs through the walls.
Why Polybutylene Pipes Fail
Chemicals in treated public water, such as chlorine, react with polybutylene over time. The pipe becomes brittle and develops tiny cracks from the inside, where you can’t see them. Fittings and joints are also common failure points.
The problem is how it fails. A polybutylene line can go from looking fine to splitting open with little or no warning. When that happens inside a wall, ceiling, or attic, water can run for hours before anyone notices.
Warning Signs to Watch For
- Water stains on ceilings or walls
- Small leaks at fittings or joints
- Discolored or flaking spots on the pipe
- Water use that rises without a reason
- Low water pressure in parts of the house
If you see any of these and you know you have polybutylene, have the whole system checked. One leak often means others are coming. Our leak detection service can find leaks hidden inside walls and under floors.
Patch It or Repipe?
Repairing one failed section stops that leak, but the rest of the pipe is the same age and material. For most homes with polybutylene, we recommend replacing the entire system.
Repiping also comes up when you sell. Home inspectors often flag polybutylene, and some insurance companies ask about it. Replacing it ahead of time removes that question.
What Repiping Involves
- Inspection and plan: We confirm what pipe you have, map the routes, and decide on the replacement material.
- Choose the pipe: Most homes are repiped with PEX, a flexible plastic that resists the problems polybutylene had. Copper is another option.
- Run new lines: We cut small, targeted openings to run new pipe through walls and ceilings, which keeps drywall work to a minimum.
- Connect and test: We connect the fixtures, test the new system for leaks and pressure, and remove or disconnect the old lines.
- Patch openings: We close up the access points.
Most homes keep water service for most of the job, and many repipes are done in a few days, depending on the size of the home.
Get an Answer About Your Pipes
Guy Smith Home Services has served Virginia Beach homeowners since 1968. If you think your home has polybutylene, our licensed plumbers can inspect it and explain your options with upfront pricing. Learn more about our repiping services, or contact us to schedule an inspection.