Water at the bottom of a water heater usually comes from one of three places: the drain valve, the temperature and pressure relief valve’s discharge pipe, or the tank itself. A leaking drain valve or relief valve can often be repaired. A leak from the tank usually means the tank has rusted through and needs to be replaced.
What to Do Right Away
- Turn off the power or gas. For an electric heater, switch off the breaker. For a gas heater, turn the gas control to “off” or “pilot.”
- Shut off the cold water supply. Close the valve on the cold water line at the top of the heater.
- Protect the area. Move stored items away and soak up the water. If the heater is in a closet or attic, check the ceiling and floor below.
- Don’t touch hot water. Water in the tank can be hot enough to burn.
If water is spreading fast and you can’t reach the heater’s valve, shut off the main water to the house.
Common Causes of a Leak at the Bottom
Loose or Faulty Drain Valve
The drain valve near the bottom of the tank is used to flush sediment. If it’s loose or worn, it can drip. Try tightening it by hand. If it keeps dripping, the valve can be replaced without replacing the tank.
Temperature and Pressure Relief Valve
This safety valve releases water if the tank’s temperature or pressure gets too high. Its discharge pipe runs down the side of the tank and often ends near the floor, so a leak here can look like it’s coming from the bottom. Occasional drips can mean the valve is wearing out. Frequent discharge can mean the water pressure or temperature is too high. Either way, have it checked. Never cap or plug this valve.
Condensation
A new heater or a gas heater filled with cold water can form condensation that drips onto the burner area. This usually stops once the tank warms up. If the water keeps coming, look for another cause.
A Leaking Tank
Over time, sediment and minerals settle at the bottom of the tank, and the steel inside starts to corrode. Once rust eats through the tank, water seeps out from underneath. A tank leak can’t be repaired. The heater needs to be replaced.
Signs the tank itself is leaking:
- Water pooling with no drip from the valves or fittings
- Rust on the bottom of the tank
- Rusty or discolored hot water
- A heater that’s 10 years old or older
Repair or Replace?
If the leak comes from a valve or fitting and the heater is otherwise in good shape, a repair usually makes sense. If the tank is leaking, or the heater is old and has had other problems, replacement is the better call.
When you replace, it’s a good time to compare a standard tank with a tankless water heater. Tankless units heat water as you use it, so there’s no tank to rust through.
How to Help Your Next Heater Last
- Flush the tank once a year to clear sediment.
- Have the anode rod checked every few years.
- Test the relief valve once a year.
- Keep the area around the heater clear so leaks are easy to spot.
- Install a drain pan with a drain line, especially for heaters in attics or upper floors.
Get Help With a Leaking Water Heater
Guy Smith Home Services has served Virginia Beach homeowners since 1968. Our licensed plumbers repair and replace tank and tankless water heaters, with upfront pricing before any work begins. Learn more about our water heater services, or contact us to schedule a repair.